Create a symmetrical ruler [PRO/EX]
The following rulers are provided in the sub tools of the Ruler tool. The initial configuration of the sub tools has been changed from Ver.1.6.2. For those who are used to a previous version of Clip Studio Paint, this operation is now performed by selecting the Figure tool and then selecting Create ruler on the Sub Tool palette. The right and left symmetrical ruler relative to the center of the canvas. I made it to save the trouble of drawing a ruler. キャンバスの中心を基準とした、左右対称定規です。 定規を引く手間を省くために作りました。.
Allows you to configure the number of the lines of a symmetrical ruler and how to make it symmetric when using the [Symmetrical ruler] sub tool.
Configures the number of lines which can be drawn concurrently when drawing by snapping to the symmetrical ruler.
Configures the number of lines which can be drawn concurrently when drawing by snapping to the symmetrical ruler.
(2)Line symmetryWhen turned on, the line symmetry ruler is created. When turned off, the rotation symmetry ruler is created.
(3)Step of angleAllows you to configure the angle by which the object will rotate each time.
(4)Create at editing layerClip Studio Paint Symmetry Tool
When turned on, the ruler is created on the layer being edited. When turned off, a new layer for rulers is created.
